Table of Contents
Advertisement
Troubleshooting
TDU Event /
Error Code
0x18
0x19
98
Number
of Red
LED
Flashes
Definition
9
Following error trip
10
Error input triggered
T2100 Treadmill
Check These Items
Position or velocity following error.
Following errors could be caused by
a badly tuned drive controller/motor,
especially at high acceleration and
deceleration rates where the following
error will typically be greater. Following
error could also be the caused by
encoder/resolver loss.
1.
Powercycle the T2100 Treadmill
and monitor the T2100 Treadmill
for reoccurrence of this error. (This
may be an isolated incident.)
2.
Confirm that the motor is not
overloaded or stalling.
3.
Determine if any TDU
Troubleshooting Table errors
are also being reported, and if
so, follow the troubleshooting
procedure for the reported errors.
4.
Replace the drive controller.
Indicates a user-defined condition has
been activated and generated an error.
1.
Powercycle the T2100 Treadmill
and monitor the T2100 Treadmill
for reoccurrence of this error. (This
may be an isolated incident.)
2.
Determine if any TDU
Troubleshooting Table errors
are also being reported, and if
so, follow the troubleshooting
procedure for the reported errors.
3.
Replace the drive controller
2021403-120F
Advertisement
Table of Contents
Troubleshooting
