GE T2100 Service Manual page 129

Item
5
6
7
8
9
10
11
12
NOTE:
Electrostatic discharge can harm the PCB boards and power supply. The following
guidelines help protect the PCB boards and power supply from ESD damage.
• Keep the new PCB boards and power supply in their anti-static bags until they
are ready to be installed.
• Discharge any static charge you may have built up before handling the PCB
boards and power supply. (Touch a metal surface to discharge a spark.)
• Handle the PCB boards and power supply by their edges. Do not touch the
semi-conductor components.
1. Turn the ON/OFF switch to the OFF position, disconnect the power cord from the
wall outlet, and remove the shroud.
2. Remove the e-box cover.
3. Disconnect any wiring harnesses/connections.
4. Unscrew the mounting screws.
5. Reconnect any wiring harnesses/connections.
6. Replace the e-box cover and the shroud.
7. Calibrate the T2100 Treadmill. See
2021403-120F
Description
Power PCB to 24V Power Supply Harness
Power-In Harness
Switch to Filter Harness
EMI Filter
Filter to Power PCB Harness
Power PCB
Ribbon Cable from Power PCB to Processor PCB
Elevation Cap Harness
T2100 Treadmill
"Self-Calibration" on page
FRU Replacement
45.
129