GE T2100 Service Manual page 50

Installation
Procedure
Can the unit elevate?
Can the walking belt move
with power?
Speed check at 2 m.p.h.
(3.2km/h) = 10 revs in 38
seconds.
(Adhere a piece of tape to
the walking belt and count
10 revs of the tape in 38
seconds.)
Is the walking belt tracking
evenly down the center of
the walking board?
Check the walking belt
tightness. Get on the T2100
Treadmill and try to stop the
belt at a slow speed with
your feet, holding onto the
handrail.
Check T2100 Treadmill Level
Is the unit level and stable?
Is the floor under the unit
smooth and no loose tiles?
Check the drive belt tension
and tracking.
See "Drive Belt Adjustments"
on page
tension and tracking
tolerances.
50
Indicate
Pass/Fail
117for specific
T2100 Treadmill
If Failed, perform the following:
1. Initiate the self-calibration
procedure. See
"Self-Calibration" on page
45.
2. Follow the troubleshooting
procedure error code 0x03 in
"TDU Troubleshooting Table"
on page 84.
1. Is the Emergency Stop Switch
locked? If yes, unlock.
2. Initiate the self-calibration
procedure. See
"Self-Calibration" on page
45.
3. Follow the troubleshooting
procedure for error code
0x02 in "TDU Troubleshooting
Table" on page 84.
Initiate the self-calibration
procedure. See "Self-Calibration"
on page 45.
Adjust belt tracking. See "Walking
Belt Tracking Adjustment" on page
55.
Adjust the belt tension.
See "Walking Belt Tension
Adjustment" on page 55.
If unit is not level, adjust.
Relocate the T2100 Treadmill.
1. Adjust the drive belt tension
and tracking .See "Drive Belt
Adjustments" on page
2. Call tech support.
Indicate
Pass/Fail
117.
2021403-120F