Drive Controller Status Led - GE T2100 Service Manual

Drive Controller Status LED

The drive controller fault status LED is located underneath the X6 connector on the
Drive Controller. Remove the shroud to view the LED.
Arrow points to the Drive Controller fault status LED
LED Status
Solid Green
Flashing Green
Alternating
Red/Green Flashing
LED is OFF
Flashing Red
2021403-120F
Drive enabled, normal operation.
Firmware download in progress.
Solid Red Drive is disabled, but no errors are latched.
Undervoltage warning (no AC power to the X1 connector), but no
errors are latched.
Check the 24 VDC control circuit supply is connected correctly to
the X2 connector and is powered on.
Powerbase fault or error(s) present. The number of flashes
indicates which error has occurred. For example, to display error 3
(overcurrent trip), the LED flashes 3 times at 0.1 second intervals,
followed by a 0.5 second pause. The sequence is repeated
continuously.
If multiple errors occur at the same time, the lowest numbered
error code will be flashed. For example, a MicroFlex which has
tripped on both feedback error (code 5) and over-current error
(code 3) will flash error code 3. If the drive is already displaying an
error code when a new error with a lower code occurs, the drive will
start flashing the new code. Note that undervoltage trip does not
appear in the table because it is already indicated by the green/red
flashing state. If an undervoltage trip occurs in conjunction with
another error, the drive will flash the code of the additional error.
See the troubleshooting table below for the event/error code and
it's corresponding red flashing LED.
T2100 Treadmill
Description
Troubleshooting
93