Installation Checklist - GE T2100 Service Manual

Installation
If you are moving the T2100 Treadmill after it has been in operation, use the controlling
equipment to set the grade to approximately 7%. Then remove power and disconnect
all cables to the T2100 Treadmill before moving the unit.
NOTE:
We recommend the T2100 Treadmill not be placed on carpet or carpet tile floors
as a final location, as continual movement of the wheels may eventually damage
the carpet and possibly the T2100 Treadmill.
WARNING:
INJURY OR DAMAGE. The T2100 Treadmill is too heavy to lift, lower or move safely
by one person. Serious bodily injury or damage to the T2100 Treadmill may result.
A minimum of two people are required when lifting, lowering or moving the T2100
Treadmill.
1. Lift the end of the bed assembly to about knee height, keeping knees bent and
back straight as you lift.
2. Rotate the T2100 Treadmill in the direction you want to go (the T2100 Treadmill
will pivot on its wheels) and push forward.
3. When you have maneuvered the T2100 Treadmill into its new location, gently
lower the end of the bed assembly to the floor.

Installation Checklist

The Installation Checklist is provided as a guide for the field engineer when installing
a T2100 Treadmill. Follow the procedures in this instruction in the order that they
are written and appear.
As you complete each item, check it off in the list below.
• "Electrical Safety Tests" on page 39
• Assemble the T2100 Treadmill:
• "Pre-Assembly Inspection" on page 40
• "Install Handle Set" on page 40
• "Install Emergency Stop Switch" on page 42
• "Power Cord and Plug" on page 43
• "Ground Continuity Test" on page 43
38
T2100 Treadmill
2021403-120F