GE T2100 Service Manual page 124

FRU Replacement
elevation shaft such that the mounting plate is within 1/16 inch or less of the
threaded stand-offs.
6. Secure the mounting plate with the appropriate screws.
7. Connect the other end of the harness to the Control PCB as required.
8. Power on the unit and run calibration to ensure proper operation of elevation
system.
9. Test the T2100 Treadmill using the CASE system (or other controlling device) to
ensure the T2100 Treadmill is capable of reaching its lower and upper limits.
Confirm that the requested vs. actual elevation (as reported by the following
CASE application screen example) match at 0% grade and at 25% grade. If the
actual elevation does not reach 25% grade, the 1–2 turns preset established in
124
Item
Description
1
Mounting Plate Hole
2
Threaded Standoff
T2100 Treadmill
2021403-120F