Walking Board Replacement Instructions - GE T2100 Service Manual

FRU Replacement
5. On the front right side of the T2100 Treadmill, remove the eight, 1/2 inch bolts
that hold the frame's sliding bracket in place.
6. Slide the bracket left, into the frame.
NOTE:
7. Slide the belt between the rear and front roller, removing the belt from the rear
roller first.
8. Replace the walking board before installing a new walking belt. See
Board Replacement Instructions" on page
NOTE:

Walking Board Replacement Instructions

1. Remove the walking belt as instructed in the previous steps.
2. Remove the eight, 5/32 inch Allen-head, counter-sunk screws from the top of
the walking board. (The fastening nuts on the underside of the T2100 Treadmill
are welded in place.)
3. Lift the walking board off the T2100 Treadmill.
112
Item Descriptions
1
Sliding Bracket Bolts
(4 on each side)
2
Sliding Bracket
Do not worry if the bracket slides in too far. During reassembly you can lift
the back end of the T2100 Treadmill and the bracket will slide back where
you can reach it.
The wax material on the walking board acts as a lubricant for the belt. We
recommend that you replace the walking board every time you put on a new
walking belt to ensure the belt absorbs the required amount of lubricant.
T2100 Treadmill
112.
"Walking
2021403-120F