Siemens SINAMICS G150 Operating Instructions Manual page 67

Item Activity
Safety Integrated
34 Option K01
Safety license
for 1 axis
35 Option K82
"Safe Torque
Off" and "Safe
Stop 1" safety
functions
36 Option K87
TM54F Terminal
Module
37 Option K88
Safe Brake
Adapter
230 VAC
Required tools
You require the following tools for the electrical installation:
● Standard set of tools with screwdrivers, screw wrenches, socket wrenches, etc.
● Torque wrenches 1.5 Nm up to 100 Nm
● 600 mm extension for socket wrenches
Converter cabinet units
Operating Instructions, 07/2016, A5E03347396A
A license is required for each axis with safety functions in the
case of Safety Integrated Extended Functions.
With Option K01, the safety license for 1 axis is contained in and
activated on the compact flash card (see "Electrical installation /
Other connections / Safety license for 1 axis (option K01)").
The terminal block -X41 must be connected on site, the safety
functions must be activated prior to use via parameter assign-
ment, in addition an acceptance test must be performed and an
acceptance report must be drawn up (see "Electrical installation /
Other connections / Terminal Module for activating "Safe Torque
Off" and "Safe Stop 1" (option K82)").
The terminal blocks of TM54F Terminal Module must be connect-
ed line-side; the Safety Integrated Extended Functions must be
activated prior to use via parameter assignment; in addition an
acceptance test must be performed and an acceptance report
must be drawn up (see "Electrical installation / Other connections
/ TM54F Terminal Module (option K87)").
To control the brake, a connection must be established between -
X14 on the Safe Brake Adapter and the holding brake (see "Elec-
trical installation / Other connections / SBA Safe Brake Adapter
230 VAC (option K88)").
Electrical installation
4.2 Checklist for electrical installation
Yes Completed
67