Adjusting The Camera - Sony PCS-6000 Operating Instructions Manual

Adjusting the Camera

To select the camera to be adjusted
You can adjust the local camera to obtain the best viewing results.
During communication, you can also adjust the remote camera, and adjust
images being sent from the remote camera.
Notes
• A malfunction may occur if the local and remote parties try to adjust the
same camera at the same time.
• You cannot control the remote camera during a meeting if H.281 is not
selected as the far end camera control protocol.
• You cannot control the remote camera during a meeting if the Multimedia
Terminal is used as the multipoint terminal.
• When you operate a remote camera, you cannot control backlight,
brightness, and automatic adjustment of the focus and brightness.
To display the picture on the whole screen
When you adjust the camera, press the PinP button on the Remote
Commander. The picture will be displayed on the whole screen. To return
to the previous screen, press the joystick, the RETURN button, or the PinP
button on the Remote Commander.
Before adjusting the camera, you must select the local or remote camera to
be controlled.
1
Press the FAR/NEAR button on the Remote Commander.
The Display Control menu appears.
Display Control
Display Control
Far Near
2
Select the far or near camera from Control with the joystick on the
Remote Commander, then press the joystick.
When the remote camera is selected, the indication [FAR] appears on the
monitor screen.
When the local camera is selected, the indication [FAR] does not appear on
the monitor screen.
Note
You cannot control the remote camera if you do not set Far End Camera
Control to On in the Dial Setup menu at the local, and set Far End Camera
Control to On in the Answer Setup menu at the remote and set Control by
Far End to On in the General Setup menu at the remote.
Chapter 2 Basic Operation During a Meeting
71