Sony PCS-6000 Operating Instructions Manual page 2

Owner's Record
The model and the serial numbers are located at the bottom.
Record the serial number in the space provided below. Refer
to these numbers whenever you call upon your Sony dealer
regarding this product.
Model No. PCS-6000/6000P
Serial No. ______________
WARNING
To prevent fire or shock hazard, do not
expose the unit to rain or moisture.
To avoid electrical shock, do not open the
cabinet. Refer servicing to qualified
personnel only.
THIS APPARATUS MUST BE EARTHED.
For the customers in the USA
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own
expense.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority
to operate this equipment.
The shielded interface cable recommended in this manual
must be used with this equipment in order to comply with the
limits for a digital device pursuant to Subpart B of Part 15 of
FCC Rules.
2
IMPORTANT INSTRUCTION TO USERS
1. This equipment complies with Part 68 of the FCC Rules.
On the bottom of this equipment is a label that contains,
among other information, the FCC registration number for
this equipment. If requested, this information must be
provided to the telephone company.
2. If this terminal equipment causes harm to the telephone
network, the telephone company will notify you in advance
that temporary discontinuance of service may be required.
But if advance notice is not practical, the telephone
company will notify the customer as soon as possible.
Also, you will be advised of your right to file a complaint
with the FCC if you believe it is necessary.
3. The telephone company may make changes in its facilities,
equipment, operations or procedures that could affect the
operation of the equipment. If this happens the telephone
company will provide advance notice in order for you to
make necessary modifications to maintain uninterrupted
service.
4. If trouble is experienced with this equipment for repair or
warranty information, please contact Sony Business
Information Center 1-800-686-7669. If the equipment is
causing harm to the telephone network, the telephone
company may request that you disconnect this equipment
until the problem is resolved.
5. This equipment cannot be used on public coin phone
service provided by the telephone company. Connection to
party line service is subject to state tariffs.
For the Customers in EU countries
Hereby, Sony Corporation, declares that this PCS-P600P is
in compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC.
The PCS-P600P is intended to be connected to the ISDN
using basic rate access interface in accordance with CTR 3
protocol or primary rate access interface in accordance with
CTR 4 protocol.
This manual focuses on using ISDN lines to conduct a
videoconference, but it also covers non-ISDN lines. If you
use ISDN lines, consult your Sony dealer for more
information.
• The ISDN service may not be available in some areas.