Sony PCS-6000 Operating Instructions Manual page 67

If you are operating the system when a call comes in
When the system fails to make a connection
When the optional PCS-UC601 Upgrade Kit has been installed
When connected over ISDN
Select OK with the joystick on the Remote Commander, then press the
joystick, or press the CONNECT/DISCONNECT ( / ) button on the
Remote Commander.
Once the connection has been made, the remote party appears on the local
monitor screen, and local party appears on the remote screen. You are now
ready to hold your meeting.
The indication "MEETING STARTS!" appears on the monitor screen.
If you do not want to receive a call
Select Cancel with the joystick, then press the joystick. The Multimedia
Terminal stops ringing.
The indication "Incoming Call. Respond?" appears on the monitor screen.
If you receive the call, Select OK with the joystick on the Remote
Commander, then press the joystick. If you cannot receive the call
according to your current operations, Select Cancel with the joystick on
the Remote Commander, then press the joystick.
The indication "CANNOT COMPLETE CONNECTION" appears along
with an ISDN cause code and a message on the monitor screen.
For details on ISDN cause codes and messages, see "On Screen Messages" on
page 124.
If a call comes in via the ISDN line during the meeting on a LAN, the
Multimedia Terminal cannot receive the call since the unit is busy.
When a call request comes in over a LAN while you are connected over
ISDN, this unit will refuse to accept the call, even if you have installed the
optional LAN software upgrade.
Chapter 2 Basic Operation During a Meeting
67