Preparing A Monitor - Sony PCS-6000 Operating Instructions Manual

Preparing the System

Preparing a Monitor

To install the IR repeater
18
Chapter 1 Preparation
Note
The IR repeater cannot be used with an RGB monitor, an LCD projection
monitor, or monitors other than Sony products.
Insert the IR repeater below the remote sensor of the TV monitor. Once
you set the IR repeater, you can turn on the Multimedia Terminal and a
Sony TV monitor together by pressing the I/1 button on the Remote
Commander or Desktop Terminal.
If the IR repeater does not function properly, set Monitor Mode in the
General Setup menu to MODE2 (PCS-6000); to MODE4 (PCS-6000P).
For details on the Monitor Mode setting, see "General Setup Menu" on page 39.
~
AC IN
AUDIO DESKTOP
LINE IN TERMINAL CAMERA IN
MIC IN CTRL S IR OUT
1 2 1 2
to IR OUT1
When using a Sony TV monitor
The TV monitor can be operated from the Remote Commander.
For details on operating the Remote Commander, see "To operate a Sony TV
monitor" on page 123.
To adjust the TV monitor screen
Use the controls on the TV monitor to adjust the screen (picture, hue,
contrast, brightness, and sharpness).
For details on adjusting the screen, refer to the operating instructions supplied
with the TV monitor.
Note
Do not activate the surround function of the TV monitor. This causes
strange sounds since the echo canceler on the Multimedia Terminal will
not function properly.
Remote sensor
IR repeater (supplied)