Table of Contents
Advertisement
Page 2
Standby Mode: Selects whether to turn into standby mode.
On: Turns into standby mode.
Off: Does not turns into standby mode.
Standby Time: Specifies the time to turn into standby mode. This is set
between 1 to 99 minutes.
Time Display: Selects whether to display the elapsed time.
On: Displays the elapsed time.
Off: Does not display the elapsed time.
Clock Set: Sets up the clock.
General Setup
Page: 2/3
Language:
English
Monitor Mode:
MODE1
Desktop Terminal Switch:
Standby
VGA/XGA:
640 x 480
Control by Far End:
On
Controller:
Remote Commander
Save
Language: Selects the language of the messages.
English: Displays messages in English.
French: Displays messages in French.
German: Displays messages in German.
Japanese: Displays messages in Japanese.
Spanish: Displays messages in Spanish.
Italian: Displays messages in Italian.
Chinese: Displays messages in Chinese.
Note
When you change the setting and save it, the computer is re-booted.
If you upgrade from software versions earlier than version 5.0, you cannot
select Chinese as the language for messages.
Monitor Mode: Selects the remote control mode of the IR repeater.
Normally, set it to MODE1 (PCS-6000) or to MODE3 (PCS-6000P).
MODE1: Sets it to mode 1.
MODE2: Sets it to mode 2.
MODE3: Sets it to mode 3.
MODE4: Sets it to mode 4.
MODE5: Sets it to mode 5.
Desktop Terminal Switch: Selects the function of the I/1 button on
the Desktop Terminal.
Standby: Assigns it as the standby button.
Power Off: Assigns it as the power-off button.
VGA/XGA: Selects the resolution of the monitor.
640×480: Sets the resolution to 640×480.
1024×768: Sets the resolution to 1024×768.
Cancel
Chapter 1 Preparation
41
Advertisement
Table of Contents
