Block %2: Approach Path Too Small; Block %2: Retract Path Too Small; Block %2: Swivel Data Record Unknown - Siemens Sinamics S120 Diagnostic Manual

Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Reduce plane infeed.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61223 [Channel %1: ] Block %2: Approach path too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The approach path must not be less than zero.
Alarm triggered by following cycles: E_MI_CON, F_MI_CON.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Enter a greater value for the approach path.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61224 [Channel %1: ] Block %2: Retract path too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The retract path must not be less than zero.
Alarm triggered by following cycles: E_MI_CON, F_MI_CON.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Enter a greater value for the retract path.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61225 [Channel %1: ] Block %2: Swivel data record unknown
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An attempt was made to access a swivel data block which has not been defined.
Alarm triggered by following cycles: E_TCARR, F_TCARR.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Select another swivel data block or define a new swivel data block.
Program Clear alarm with the RESET key. Restart part program
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
409