Block %2: Thread Length Too Short; Block %2: Wrong Definition Of Tapping Axis Transformation Ratio; Block %2: Insertion Angle = 0 For Insertion With Oscillation Or Helix; Perpendic. Approach/Retraction During Contour Milling Allowed With G40 - Siemens Sinamics S120 Diagnostic Manual

61126 [Channel %1: ] Block %2: Thread length too short
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE840.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Program lower spindle speed or raise reference point (reference plane).
Program Clear alarm with the RESET key. Restart part program
Continuation:
61127 [Channel %1: ] Block %2: Wrong definition of tapping axis transformation ratio
(machine data)
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE84, CYCLE840.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check machine data 31050 and 31060 in the appropriate gear stage of the drilling axis.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61128 [Channel %1: ] Block %2: Insertion angle = 0 for insertion with oscillation or helix
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: SLOT1.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check parameter _STA2.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61129 [Channel %1: ] Block %2: perpendic. approach and retraction during contour milling
only allowed with G40
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE72.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
391