Block %2: Line Range Too Large: %4; Block %2: Program Name %4 Illegal; Block %2: Error Affecting Coordinate Conversion (%4) - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
61041 [Channel %1: ] Block %2: Line range too large: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The alarm is triggered by the following cycles:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Program Clear alarm with the RESET key. Restart part program
Continuation:
61042 [Channel %1: ] Block %2: Program name %4 illegal
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The alarm is triggered by the following cycles: CYCLE63, CYCLE64, CYCLE952
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: In the case of multi-channel systems, the main program name must not end with _Cxx (xx stands for figures).
Rename main program.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61043 [Channel %1: ] Block %2: Error affecting coordinate conversion (%4)
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The alarm is triggered by the following cycles: F_SP_RP, F_SP_RP2, F_SP_RPB
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: 1: Type not specified
2: Error during tool identification
3: Meas. point 1 not available
4: Meas. point 2 not available
5: Meas. point 3 not available
4: Meas. point 4 not available
7: No reference point available
8: No direction of approach
9: Meas. points are identical
10: Alpha is incorrect
11: Phi is incorrect
12: Incorrect direction of approach
13: Lines do not intersect
14: Planes not available
15: No frame or incorrect frame selected
16: Not enough memory available
17: Internal error
Program Clear alarm with the RESET key. Restart part program
Continuation:
380
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms