Block %2 Accessing This Variable As Single Character Not Possible %3; Block %2 Skip Id/Label In Control Structure Not Allowed - Siemens Sinamics S120 Diagnostic Manual

Remedy: Correct INI file or correct MD and create new INI file (via "upload").
Program Switch control OFF - ON.
Continuation:
12610 [Channel %1: ] Block %2 accessing single character with call-by-reference parameter
not possible %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Source string
Definitions: An attempt has been made to use a single character access for a call-by-reference parameter.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Temporarily store single characters in user-defined CHAR variable and transfer this.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
12620 [Channel %1: ] Block %2 accessing this variable as single character not possible %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Source string
Definitions: The variable is not a user-defined variable. The single character access is only allowed for user-defined variables
(LUD/GUD).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Temporarily store variable in user-defined STRING, process this and put back into storage.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
12630 [Channel %1: ] Block %2 skip ID/label in control structure not allowed
Parameters: %1 = Channel number
%2 = Block number
Definitions: Blocks with control structures (FOR, ENDIF, etc.) cannot be concealed and must not contain any labels.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program: Reproduce skip ID via an IF query. Write the label alone in the block before the control structure
block.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
135