Saving Settings To An Operator Panel - Siemens SINAMICS G120 Operating Instructions Manual

Low voltage converters built-in and wall mounting units with cu230p-2 control units

Hide thumbs Also See for SINAMICS G120:

Table of Contents

Saving settings to an operator panel

You can transfer the inverter settings to the Operator Panel BOP‑2 or vice versa, the data from

the BOP‑2 to the inverter.

Precondition

The inverter power supply has been switched on.

Inverter → BOP-2

To back up the settings on the BOP-2, proceed as follows:

You have backed up the settings on the BOP-2.

BOP-2 → inverter

To transfer the settings to the inverter, proceed as follows:

4. Switch off the inverter power supply.

Converter with the CU230P-2 Control Units

Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE

1. In the "OPTIONS" menu, select "TO BOP".

2. Start data transfer with OK.

3. Wait until the inverter has backed up the settings to the BOP‑2.

1. In the "OPTIONS" menu, select "FROM BOP".

2. Start data transfer with OK.

3. Wait until the inverter has written the settings to the memory card.

Saving the settings and series commissioning

7.3 Saving settings to an operator panel

Show Quick Links

Table of Contents

Sinamics g120p