Installing
4.5 Connecting the interfaces for the inverter control
4.5
Connecting the interfaces for the inverter control
4.5.1
Plugging the Control Unit onto the Power Module
Installing the Control Unit - General
Each Power Module has an appropriate holder for the Control Unit and a release mechanism.
Inserting the Control Unit
Proceed as follows to plug the Control Unit onto a Power Module:
1. Place the two catches of the Control
Unit in the matching grooves of the
Power Module.
2. Press the Control Unit onto the
Power Module until you hear that it
latches.
You have now plugged the Control Unit onto the Power Module.
Removing the Control Unit
Remove the Control Unit from the Power Module by pressing the release mechanism.
Special features for the PM330 Power Module
To insert or detach the Control Unit, you must open the left-hand
cover of the Power Module.
Close the cover before you commission the inverter.
106
Converter with the CU230P-2 Control Units
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE