Siemens RUGGEDCOM ROS v4.3 User Manual page 54

Chapter 2
Using ROS
Command
purgemac
random
reset
resetport { all |
rmon
route
sfp
port { base | alarms |
diag | calibr | thr | all | no
parameter specified }
sql { default | delete | help |
info | insert | save | select |
update }
sshkeygen
keytype
38
Description
• address is the target IP address.
• count is the number of echo requests to send. The default is 4.
• timeout is the time in milliseconds to wait for each reply. The range is 2 to 5000
seconds. The default is 300 milliseconds.
Purges the MAC Addrtess table.
Display seeds or random numbers.
Perform a hard reset of the switch.
Resets one or more Ethernet ports, which may be useful for forcing re-negotiation of speed
ports }
and duplex, or in situations where the link partner has latched into an inappropriate state.
Optional and/or required parameters include:
• all resets all ports
• ports is a comma separated list of port numbers (e.g. 1,3-5,7)
Displays the names of all RMON alarm eligible objects.
Displays the gateway configuration.
Displays SFP (Small Form Factor Pluggable) device information and diagnostics. If optional
or required parameters are not used, this command displays the base and extended
information.
Optional and/or required parameters include:
• port is the port number for which the data are required
• base displays the base information
• alarms displays alarms and warning flags
• diag displays measured data
• calibr displays calibration data for external calibration
• thr displays thresholds data
• all displays all diagnostic data
Provides an SQL-like interface for manipulating all system configuration and status
parameters. All commands, clauses, table, and column names are case insensitive.
Optional and/or required parameters include:
• default sets all records in a table(s) to factory defaults
• delete allows for records to be deleted from a table
• help provides a brief description for any SQL command or clause
• info displays a variety of information about the tables in the database
• insert enables new records to be inserted into a table
• save saves the database to non-volatile memory storage
• select queries the dtabase and displays selected records
• update enable existing records in a table to be updated
For more information about the sql command, refer to
Commands"
Generates new SSH keys in ssh.keys.
N
Optional and/or required parameters include:
• keytype is the type of key, either rsa or dsa
• N is the number of bits in length. The allowable sizes are 1024, 2048 or 3072
NOTE
The device to be pinged must support ICMP echo. Upon commencing the ping,
an ARP request for the MAC address of the device is issued. If the device to be
pinged is not on the same network as the device pinging the other device, the
default gateway must be programmed.
.
RUGGEDCOM ROS
User Guide
Section 2.6.4, "Using SQL
Available CLI Commands