Configuring Ntp Servers - Siemens RUGGEDCOM ROS v4.3 User Manual

Chapter 5
Setup and Configuration
1.
NOTE
If the device is running as an NTP server, NTP service must be enabled.
Navigate to Administration » System Time Manager » Configure NTP » Configure NTP Service . The SNTP
Parameters form appears.
2
Figure 125: SNTP Parameters Form
1. SNTP Options 2. Apply Button 3. Reload Button
2. Select Enabled to enable SNTP, or select Disabled to disable SNTP.
Click Apply.
3.
Section 5.5.2.2

Configuring NTP Servers

To configure either the primary or backup NTP server, do the following:
Navigate to Administration » System Time Manager » Configure NTP » Configure NTP Servers . The NTP
1.
Servers table appears.
Figure 126: NTP Servers Table
2. Select either Primary or Backup. The NTP Servers form appears.
196
RUGGEDCOM ROS
User Guide
1
3
Configuring NTP Servers