Deleting An Snmp User - Siemens RUGGEDCOM ROS v4.3 User Manual

RUGGEDCOM ROS
User Guide
Parameter
v1/v2c Community
Auth Protocol
Priv Protocol
Auth Key
Confirm Auth Key
Priv Key
Confirm Priv Key
4. Click Apply.
Section 5.6.1.3

Deleting an SNMP User

To delete an SNMP user, do the following:
Navigate to Administration » Configure SNMP » Configure SNMP Users . The SNMP Users table appears.
1.
Deleting an SNMP User
Description
generated to trap receivers if request was received from this user,
but from any other IP address.If IP address is empty, traps can not
be generated to this user, but SNMP requests will be served for
this user from any IP address.
Synopsis: Any 32 characters
The community string which is mapped by this user/security name
to the security group if security model is SNMPv1 or SNMPv2c. If
this string is left empty, it will be assumed to be equal to the same
as user name.
Synopsis: { noAuth, HMACMD5, HMACSHA }
Default: noAuth
An indication of whether messages sent on behalf of this user to/
from SNMP engine, can be authenticated, and if so, the type of
authentication protocol which is used.
Synopsis: { noPriv, CBC-DES }
Default: noPriv
An Indication of whether messages sent on behalf of this user to/
from SNMP engine can be protected from disclosure, and if so,
the type of privacy protocol which is used.
Synopsis: 31 character ASCII string
The secret authentication key (password) that must be shared
with SNMP client. If the key is not an emtpy string, it must be at
least 6 characters long.
Synopsis: 31 character ASCII string
The secret authentication key (password) that must be shared
with SNMP client. If the key is not an emtpy string, it must be at
least 6 characters long.
Synopsis: 31 character ASCII string
The secret encription key (password) that must be shared with
SNMP client. If the key is not an emtpy string, it must be at least 6
characters long.
Synopsis: 31 character ASCII string
The secret encription key (password) that must be shared with
SNMP client. If the key is not an emtpy string, it must be at least 6
characters long.
Chapter 5
Setup and Configuration
201