Configuring Vlans For Specific Ethernet Ports - Siemens RUGGEDCOM ROS v4.3 User Manual

RUGGEDCOM ROS
User Guide
Section 5.1.4

Configuring VLANs for Specific Ethernet Ports

When a VLAN ID is assigned to an Ethernet port, the VLAN appears in the VLAN Summary table where it can be
further configured.
To configure a VLAN for a specific Ethernet port, do the following:
Navigate to Virtual LANs » Configure Port VLAN Parameters . The Port VLAN Parameters table appears.
1.
Figure 83: Port VLAN Parameters Table
2. Select a port. The Port VLAN Parameters form appears.
6
Figure 84: Port VLAN Parameters Form
1. Port(s) Box 2. Type List 3. PVID Box 4. PVID Format Options 5. GVRP List 6. Apply Button 7. Reload Button
3. Configure the following parameter(s) as required:
Parameter
Port(s)
Type
Configuring VLANs for Specific Ethernet Ports
Description
Synopsis: Any combination of numbers valid for this parameter
The port number as seen on the front plate silkscreen of the
switch (or a list of ports, if aggregated in a port trunk).
Synopsis: { Edge, Trunk, PVLANEdge, QinQ }
Chapter 5
Setup and Configuration
1
2
3
4
5
7
143