Lift Cylinder Service - Toro Sand Pro 5040 Service Manual

Lift Cylinder Service

1
2
1. Barrel
2. Nut
3. Seal
4. Piston
Disassembly (Fig. 52)
1. Remove oil from lift cylinder into a drain pan by slowly
pumping the cylinder shaft. Plug both ports and clean
the outside of the cylinder.
IMPORTANT: Prevent damage when clamping the
lift cylinder into a vise; clamp on the clevis end of
the barrel ONLY.
Hydraulic System
3
2
4
5 1
4
3
Figure 52
5. O–ring
6. Rod seal
7. O–ring
8. Backup seal
Page 4 – 62
5
6
7
8
9
6
11
7 8
9. Head
10. Dust seal
11. Retaining ring
12. Shaft
2. Mount lift cylinder securely in a vise by clamping on
the clevis end of the barrel.
3. Using a spanner wrench, rotate head clockwise until
the edge of the retaining ring appears in the barrel open-
ing. Insert a screwdriver under the beveled edge of the
retaining ring to start the retaining ring through the open-
ing. Rotate the head counter–clockwise to remove re-
taining ring from barrel and head.
Sand Pro & Infield Pro 3040/5040
10
11
12
10
12
9