Toro Sand Pro 5040 Service Manual page 89

Removal (Fig. 51)
1. Park machine on a level surface, lower attachment,
stop engine, apply parking brake and remove key from
ignition switch.
2. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
3. Thoroughly clean hydraulic hose ends and fittings on
lift cylinder to prevent hydraulic system contamination.
4. Label all hydraulic connections on lift cylinder for as-
sembly purposes.
CAUTION
Operate all hydraulic controls to relieve system
pressure and avoid injury from pressurized hy-
draulic oil.
5. Disconnect hydraulic hoses from lift cylinder. Allow
hoses to drain into a suitable container.
6. Put caps or plugs on disconnected hoses and fittings
to prevent contamination.
7. Remove cotter pin from one end of cylinder pin (item
16) that secures cylinder clevis to hitch tube. Slide cylin-
der pin from hitch tube and lift cylinder.
Sand Pro & Infield Pro 3040/5040
8. Remove cap screw (item 24) and washer (item 25)
that secure lift cylinder to frame.
9. Remove lift cylinder from machine.
10.Remove hydraulic fittings from lift cylinder if re-
quired. Mark fitting location and orientation to allow cor-
rect assembly before removing fittings from lift cylinder.
Installation (Fig. 51)
1. If fittings were removed from lift cylinder, install fit-
tings with new o–rings using marks made during the re-
moval process to properly orientate fittings.
2. Position lift cylinder to frame and hitch tube.
3. Secure lift cylinder to frame with washer and cap
screw.
4. Install cylinder pin to secure lift cylinder to hitch tube.
Secure cylinder pin with cotter pin.
5. Remove plugs and caps placed in hoses and fittings
during removal. Use labels placed during the removal
process to properly install hoses to lift cylinder.
6. Make sure hydraulic tank is full. Add correct oil if nec-
essary (see Operator's Manual).
7. Operate machine functions slowly until air is out of
system (see Charge Hydraulic System in this section).
Page 4 – 61 Hydraulic System