Standard Torque For Dry, Zinc Plated And Steel Fasteners (Metric Fasteners) - Toro Sand Pro 5040 Service Manual

Standard Torque for Dry, Zinc Plated and Steel Fasteners (Metric Fasteners)

Class 8.8 Bolts, Screws and Studs with
Thread Size Thread Size
M5 X 0.8 57 + 6 in–lb
M6 X 1.0 96 + 10 in–lb
M8 X 1.25 19 + 2 ft–lb
M10 X 1.5 38 + 4 ft–lb
M12 X 1.75 66 + 7 ft–lb
M16 X 2.0 166 + 17 ft–lb
M20 X 2.5 325 + 33 ft–lb
NOTE: Torque values may have to be reduced when
installing fasteners into threaded aluminum or brass.
The specific torque value should be determined based
on the fastener size, the aluminum or base material
strength, length of thread engagement, etc.
NOTE: Reduce torque values listed in the table above
by 25% for lubricated fasteners. Lubricated fasteners
are defined as threads coated with a lubricant such as
engine oil or thread sealant such as Loctite.
Sand Pro & Infield Pro 3040/5040
Regular Height Nuts Regular Height Nuts
(Class 8 or Stronger Nuts)
644 + 68 N–cm
1085 + 113 N–cm
26 + 3 N–m
52 + 5 N–m
90 + 10 N–m
225 + 23 N–m
440 + 45 N–m
Page 2 – 5
Class 10.9 Bolts, Screws and Studs with
Regular Height Nuts Regular Height Nuts
(Class 10 or Stronger Nuts)
78 + 8 in–lb
133 + 14 in–lb
28 + 3 ft–lb
54 + 6 ft–lb
93 + 10 ft–lb
229 + 23 ft–lb
450 + 46 ft–lb
NOTE: The nominal torque values listed above are
based on 75% of the minimum proof load specified in
SAE J1199. The tolerance is approximately + 10% of the
nominal torque value.
Product Records and Maintenance
881 + 90 N–cm
1503 + 158 N–cm
38 + 4 N–m
73 + 8 N–m
126 + 14 N–m
310 + 31 N–m
610 + 62 N–m