Toro Sand Pro 5040 Service Manual page 69

5. Put caps or plugs on disconnected lines and fittings
to prevent contamination.
6. Remove four (4) cap screws and flange nuts that se-
cure fan shroud to frame.
7. Carefully remove oil cooler and fan shroud from ma-
chine taking care not to damage fan on hydrostat.
8. Remove two (2) cap screws, flat washers and rubber
clamps that secure oil cooler to fan shroud. Separate oil
cooler from fan shroud.
9. If hydraulic fittings are to be removed from oil cooler,
mark fitting orientation to allow correct assembly. Re-
move fittings from oil cooler.
Installation (Figs. 32 and 34)
1. If fittings were removed from oil cooler, install fittings
with new o–rings to oil cooler using marks made during
the removal process to properly orientate fittings.
2. Secure oil cooler to fan shroud with two (2) cap
screws, flat washers and rubber clamps.
3. Carefully position oil cooler and fan shroud to frame.
4. Secure fan shroud to frame with four (4) cap screws
and flange nuts.
5. Remove caps or plugs from disconnected hydraulic
lines and fittings.
6. Position new o–rings and connect hydraulic lines to
fittings on oil cooler. Use labels placed during the remov-
al process to properly install hoses to oil cooler.
7. Position center shroud to frame and secure with two
(2) cap screws and flat washers (Fig. 33).
8. Check and adjust oil level in hydraulic tank (see Op-
erator's Manual).
Sand Pro & Infield Pro 3040/5040
1. Center shroud
2. Cap screw (2 used)
SAND PRO/INFIELD
PRO 3040
1. Oil cooler
2. O–ring
o
3. 90 hydraulic fitting
4. O–ring
Page 4 – 41
2
3
Figure 33
3. Flat washer (2 used)
5
4
3
2
1
2
Figure 34
5. Hydraulic tube
6. Lift control valve
7. Hydraulic hose
Hydraulic System
1
6
7
3