Toro Sand Pro 5040 Service Manual page 46

O–Ring Kit
Part Number: 16–3799
The o–ring kit includes o–rings in a variety of sizes for
face seal and port seal hydraulic connections. It is rec-
ommended that o–rings be replaced whenever a hy-
draulic connection is loosened.
Wheel Hub Puller
Part Number: TOR4097
The wheel hub puller allows safe removal of the wheel
hub from the shaft of hydraulic wheel motors.
High Pressure Hydraulic Oil Filter
If a component failure occurs in the closed loop traction
circuit, contamination from the failed part will remain in
the circuit until removed. When connecting hydraulic
test gauges in order to test traction circuit components
or after replacing a failed traction circuit component (e.g.
hydrostat or wheel motor), a high pressure hydraulic fil-
ter can be installed in the traction circuit. The filter will
ensure that contaminates are removed from the closed
loop and thus, do not cause additional component dam-
age.
A high pressure hydraulic oil filter can be obtained local-
ly.
Hydraulic System Page 4 – 18
Figure 13
Figure 14
Figure 15
Sand Pro & Infield Pro 3040/5040