Toro Sand Pro 5040 Service Manual page 21

Removal (Fig. 3)
NOTE: See Operator's Manual for air cleaner mainte-
nance procedures and intervals.
1. Park machine on a level surface, lower attachment,
stop engine, apply parking brake and remove key from
ignition switch.
2. Remove air cleaner components as needed using
Figure 3 as a guide.
3. Check air cleaner assembly for damage that could
cause possible air leaks (Fig. 4). Make sure that air
cleaner cover seals completely to the air cleaner hous-
ing.
Installation (Fig. 3)
IMPORTANT: Any leaks in the air filter system will
allow dirt into the engine and will cause serious en-
gine damage. Make sure that all air cleaner compo-
nents are in good condition and are properly
secured during assembly.
1. Assemble air cleaner system using Figure 3 as a
guide. Make sure that vacuator valve is pointed down af-
ter assembly (Fig. 4).
Sand Pro & Infield Pro 3040/5040
2
1
1. Air cleaner housing
2. Pipe plug
3. Filter element
3
4
1. Air hose
2. Breather tube
Page 3 – 7
3
4
5
Figure 4
4. Air cleaner cover
5. Vacuator valve
2
1
Figure 5
3. Intake elbow
4. Carburetor
Gasoline Engine