Toro Sand Pro 5040 Service Manual page 27

9. Secure fuel hose to the fuel pump with hose clamp.
Remove clamp from fuel hose that was used to prevent
fuel spillage. Open fuel shutoff valve.
10.Place new intake gasket on carburetor. Position in-
take elbow to top of carburetor. Place two (2) gaskets to
top of intake elbow and secure intake elbow with four (4)
flange head screws. Torque cap screws from 60 to 65
in–lbs (6.8 to 7.3 N–m).
IMPORTANT: Any leaks in the air filter system will
allow dirt into engine and will cause serious engine
damage. Make sure that all air cleaner components
and breather tube are in good condition and are
properly secured during assembly.
11. Secure breather tube to intake elbow. Make sure that
hose clamps are properly tightened.
Sand Pro & Infield Pro 3040/5040
12.Secure air intake hose to air cleaner assembly and
engine (see Air Cleaner Assembly Installation in this
section). Make sure that hose clamps are properly tight-
ened.
13.Install hitch assembly to the rear of the machine (see
Hitch Assembly Installation in the Service and Repairs
section of Chapter 6 – Chassis).
14.Install attachment to the machine.
15.Lower operator seat.
16.Check and adjust engine oil level (See Operator's
Manual).
17.Check operation of choke and throttle cables. Adjust
if necessary (see Operator's Manual).
Page 3 – 13 Gasoline Engine