Operator Seat - Toro Sand Pro 5040 Service Manual

Operator Seat

RIGHT
FRONT
1. Operator seat
2. Flange nut (8 used)
3. LH seat adjuster
4. Carriage screw (4 used)
5. Seat shroud
6. Receptacle
7. Rivet
Removal (Fig. 16)
1. Park machine on a level surface, lower attachment,
stop engine, apply parking brake and remove key from
ignition switch.
2. Tilt seat up and disconnect wire harness electrical
connector from the seat switch.
3. Remove seat components as necessary using Fig-
ure 16 as a guide.
Chassis
21
20
19
18
17
16
2
13
15
12
14
Figure 16
8. Screw
9. Holding post
10. Bumper (2 used)
11. Jam nut (4 used)
12. Clevis pin (2 used)
13. Hair pin (2 used)
14. Lock nut
Installation (Fig. 16)
1. Install seat components using Figure 16 as a guide.
2. Connect wire harness electrical connector to the
seat switch.
Page 6 – 26
1
2
3
4
5
6
7
8
9
10
11
15. Spacer
16. Cap screw (4 used)
17. Lock washer (4 used)
18. Flat washer (4 used)
19. RH seat adjuster
20. Seat base
21. Seat switch
Sand Pro & Infield Pro 3040/5040