Toro Sand Pro 5040 Service Manual page 127

Removal (Fig. 4)
1. Park machine on a level surface, lower attachment,
stop engine, apply parking brake and remove key from
ignition switch.
CAUTION
When changing attachments, tires or perform-
ing other service, use correct blocks, hoists
and jacks. Make sure machine is parked on a
solid, level surface such as a concrete floor.
Prior to raising machine, remove any attach-
ments that may interfere with the safe and
proper raising of the machine. Always chock or
block wheels. Use jack stands or solid wood
blocks to support the raised machine. If the ma-
chine is not properly supported by blocks or
jack stands, the machine may move or fall,
which may result in personal injury.
2. Chock front wheel to prevent machine from shifting.
Using a jack or hoist, raise machine so rear wheel is off
ground. Support machine with jack stands or wooden
blocking (see Jacking Instructions in Chapter 1 – Safe-
ty).
3. Remove four (4) lug nuts and remove rear wheel.
Sand Pro & Infield Pro 3040/5040
Installation (Fig. 4)
1. Install rear wheel and secure with four (4) lug nuts.
2. Lower machine to ground.
3. Torque lug nuts evenly in a crossing pattern from 45
to 55 ft–lb (61 to 75 N–m).
Page 6 – 9 Chassis