Removal (Fig. 9)
1. Park machine on a level surface, lower attachment,
stop engine and remove key from ignition switch.
2. Make sure parking brake is disengaged.
3. Remove console from machine (see Console Re-
moval in this section).
4. Loosen jam nuts that secure parking brake cable to
brake lever bracket.
5. Remove retaining ring that secures brake cable to
brake lever. Slide brake cable from lever.
6. Remove brake cable from parking brake bellcrank
on rear cross tube of frame:
A. Remove flange nut that secures parking brake
cable end to parking brake bellcrank.
B. Slide brake cable end and spacer from shoulder
bolt.
7. Note routing of parking brake cable. Remove brake
cable from machine.
Sand Pro & Infield Pro 3040/5040
Installation (Fig. 9)
1. Position new parking brake cable to machine noting
original routing.
2. Secure brake cable to parking brake bellcrank on
rear cross tube of frame:
A. Slide spacer and brake cable end onto shoulder
bolt.
B. Secure parking brake cable end to parking brake
bellcrank with flange nut.
3. Position brake cable end to parking brake lever. Se-
cure cable end to lever with retaining ring.
4. Secure brake cable to brake lever bracket with jam
nuts.
5. Install console to machine (see Console Installation
in this section).
6. Check parking brake operation.
Page 6 – 15
Chassis