Toro Sand Pro 5040 Service Manual page 124

6. Slide flangette and bearing assembly onto the
spindle shaft so the bearing locking collar faces the
wheel.
7. Position hydraulic motor, wheel and flangettes to the
front fork.
IMPORTANT: When securing wheel motor and flan-
gettes to fork, tighten wheel motor fasteners before
tightening flangette fasteners.
8. Carefully lower machine to align wheel motor and
flangettes to fork. Make sure flangettes and wheel motor
fit snugly to the fork.
A. Secure hydraulic motor to the front fork with two
(2) socket head screws and lock nuts.
B. Secure flangettes to the fork with cap screws,
bearing tab and lock nuts.
Chassis
9. Lower machine completely to the ground. Make sure
flangettes and hydraulic motor are positioned correctly
into the fork. Tighten fasteners to secure wheel to front
fork.
10.Apply Loctite #242 (or equivalent) to bearing locking
collar set screw. Install set screw to locking collar and
torque from 90 to 120 in–lb (10.2 to 13.6 N–m).
11. Position hydraulic tube clamps to tubes and castor
fork. Secure clamps with cap screws, cover plates and
lock nuts.
Page 6 – 6 Sand Pro & Infield Pro 3040/5040