Samsung CY-SWR1100 User Manual page 65

IPv6 Connection Type: PPPoE
Select this option if your ISP requires you to use a PPPoE (Point to Point Protocol over Ethernet) connection to IPv6 Internet.
DSL providers typically use this option. This method of connection requires you to enter a Username and Password (provided
by your Internet Service Provider) to gain access to the IPv6 Internet. The supported authentication protocols are PAP and
CHAP.
You can configure the following parameters:
My IPv6 Connection is:
You can configure the following parameters:
PPPoE Session:
Username:
Password:
Verify Password:
Service Name:
MTU:
You can configure the following parameters:
Obtain IPv6:
Use the following IPv6:
Primary DNS Server:
Secondary DNS Server:
S W r u
amSung ireleSS outer Ser
Select the IPv6 Connection Type used for this configuration here.
Select the PPPoE Session value used here. This option will state that this connection
shares it's information with the already configured IPv6 PPPoE connection, or You can
create a new PPPoE connection here.
Enter the PPPoE username used here. This information is obtainable from the ISP.
Enter the PPPoE password used here. This information is obtainable from the ISP.
Re-enter the PPPoE password used here.
Enter the service name for this connection here. This option is optional.
Enter the MTU value used here. The default value is 1492.
Select this option to obtain the DNS Server addresses automatically.
Select this option to manually enter the DNS Server addresses used.
Enter the primary DNS Server address used here.
Enter the secondary DNS Server address used here.
' m
S anual
P 65
age