Required Network Information - Samsung CY-SWR1100 User Manual

Before you can configure your router's network settings, you need to gather the following information about your network:
• ADDRESS MODE� Does your modem connect to the Internet using a Dynamic (DHCP) address or does your Internet
Provider (IP) require a Static address? If your IP requires a Static address, you must get all the address parameters and
then enter them manually when you configure your router. These parameters include IP Address, Subnet Mask, Gateway
Address, and Primary DNS Address or Server IP Address. You can get the parameter information from your IP. If your
modem connects using a Dynamic address, your IP provides those parameters automatically, though you may need your
Host Name to configure the router.
• CONNECTION PROTOCOL� Does your modem connect to the Internet using PPPoE, PPTP, or L2TP? If it does, you
will need protocol specific information to configure your router. The information required for each protocol is listed in the
table below:
Protocol
PPPoE
PPTP
L2TP
If you get your Internet from a Cable company, in most cases you will not need to get Connection Protocol information, but
you will need to find out if your Address Mode is Dynamic (DHCP) or Static. If it is Dynamic, you may need your Host Name.
If it is static, you will need to get the IP Address, Subnet Mask, Gateway Address, and DNS Address to configure your router.
You can get this information from your Internet Provider.
Once you have the required network information, go to "Connecting to the Web UI" on page 11.
S W r u
amSung ireleSS outer Ser
r n
equIred etWork
Required Information
• User Name
• Password
PPPoE is commonly used by DSL providers. In most cases, these providers use Dynamic
(DHCP) addresses. If your provider uses Static addresses, you will also need to provide
the IP address.
• User Name
• Password
In most cases, PPTP protocol providers use Dynamic (DHCP) addresses. If your provider
uses Static addresses, you will also need to provide the IP Address, Subnet Mask, Gate-
way Address, and Server IP Address.
• User Name
• Password
In most cases, L2TP protocol providers use Dynamic (DHCP) addresses. If your provider
uses Static addresses, you will also need to provide the IP Address, Subnet Mask, Gate-
way Address, and Server IP Address.
' m
S anual
I
nformatIon
P 10
age