Samsung CY-SWR1100 User Manual page 54

In the next section, you can configure the more advanced wireless settings for the 5GHz frequency band.
You can configure the following parameters:
Wireless Band:
Transmit Power:
Beacon Interval:
RTS Threshold:
Fragmentation:
DTIM Interval:
Preamble Type:
Short Guard Interval: Check this box to reduce the guard interval time therefore increasing the data capacity. However,
Click the Save Settings button to accept the changes.
Click the Don't Save Settings button to discard the changes.
S W r u
amSung ireleSS outer Ser
You can view the wireless frequency band you are configuring - in the case, the 5GHz band.
This option sets the transmit power of the antennas.
Beacons are packets sent by an Access Point to synchronize a wireless network. Specify a value.
100 is the default setting and is recommended.
You can enter the RTS threshold value used. This value should remain at its default setting of
2346. If inconsistent data flow is a problem, only a minor modification should be made.
The fragmentation threshold, which is specified in bytes, determines whether packets will be
fragmented. Packets exceeding the 2346 byte setting will be fragmented before transmission.
2346 is the default setting.
You can enter the DTIM Interval value. Delivery Traffic Indication Message (DTIM) is a count-
down informing clients of the next window for listening to broadcast and multicast messages.
The default settings is 1.
Use the radio buttons to specify whether the Router should use the Short Preamble or Long
Preamble type. The preamble type defines the length of the CRC (Cyclic Redundancy Check)
block for communication between the Router and roaming wireless adapters.
it's less reliable and may create higher data loss.
' m
S anual
P 54
age