Panasonic DBS-576 Technical Manual page 348

FF2: Trunk Programming (T1 CO)
Introduction
CO Dial Tone Simulation
(all CPCs) - Version 1.0 or higher
r
Set whether the system will send a simulated CO dial tone to an extension
0
using this T1 channel (important for DID Wink-Start trunk signaling).
System
Configuration
FF1
BSSCC: T1 (CO) Channel Position
System
B=Cabinet no. 1-6
SS=Slot no. 01-12
CC=Channel no. 01-24
FF2
Trunks
Notes:
Set to "1" (Send) if the CO doesn't support dial tone (typical in U.K.).
FF3
Related Programming:
Extensions
Trunk Signal Type (pg. 2-87)
FF4
FF-/Soft Keys
SMDR for Outbound Calls
(all CPCs) - Version 1.0 or higher
Set whether outbound calls on the T1 channel will be included in SMDR records.
FF5
Groups
FF6
BSSCC: T1 (CO) Channel Position
TRS/ARS
B=Cabinet no. 1-6
SS=Slot no. 01-12
CC=Channel no. 01-24
FF7
Notes:
Applications
FF8
Related Programming:
Maintenance
SMDR Data to Serial Port (pg. 1-88)
SMDR Output Format (pg. 1-93)
Appendix A
Appendix B
Page 2-100
FF2 2 BSSCC
FF2 2 BSSCC 02 00 Hold (0-3) Hold
FF2 2 BSSCC
FF1 0 06 0001 Hold (0-2) Hold
FF1 0 09 0001 Hold (0-2) Hold
DBS 576 (USA) issued 05/20/98
03 06 Hold (0 or 1) Hold
0=Do not send simulated CO dial tone
to extension. (default)
1=Send simulated CO dial tone to extension.
03 07 Hold (0 or 1) Hold
0=Do not include in SMDR.
1=Include in SMDR. (default)
Section 400-Programming
$ 
# %
$ %
2  #-6-0#-
576-13-400
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B