Ff1 0 06: Serial Port Output Data - Panasonic DBS-576 Technical Manual

FF1: System Programming
Introduction

FF1 0 06: Serial Port Output Data

NOTE: Serial Port 1 is the "CN5" RS-232C connector on the SCC Card.
0 Serial Port 2 is the "CN6" RS-232C connector on the SCC Card. These serial
System
ports can be used for separate printer and modem connections. If you use
Configuration
these serial ports, be sure to configure them here and in the FF1 0 05: Serial
Ports addresses starting on 1-80.
FF1
System
SMDR Data to Serial Port
FF2
(all CPCs) - Version 1.0 or higher
Trunks
Set the serial port (if any) to receive SMDR data.
FF3
Extensions
FF4
FF-/Soft Keys
Notes:
FF5
Related Programming:
Groups
SMDR Output Format (pg. 1-93)
FF6
TRS/ARS
Fault Alarm Data to Serial Port
(all CPCs) - Version 1.0 or higher
FF7
Set the serial port (if any) to receive fault alarm data from the phone system.
Applications
FF8
Maintenance
Notes:
Appendix A
Appendix B
Page 1-88
FF1 0 06 0001 Hold (0-2) Hold
FF1 0 09 0001 Hold (0-2) Hold
FF1 0 06 0002 Hold (0-2) Hold
DBS 576 (USA) issued 05/20/98
Section 400-Programming
0=no output
1=Serial Port 1 (default)
2=Serial Port 2
0=none (default)
1=Serial Port 1
2=Serial Port 2
Introduction
0
Configuration
FF1
System
2  
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
 /, 
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B
576-13-400
System