Panasonic DBS-576 Technical Manual page 275

Section 400-Programming
Introduction
Indirect LCR
(all CPCs) - Version 1.0 or higher
(U.K. use only) Enable/Disable the Indirect Least Cost Routing (LCR) function.
0
System
Configuration
FF1
BSSC: Analog (CO) Trunk Position
B=Cabinet no. 1-6
System
SS=Slot no. 01-12
C=Circuit no. 1-8
FF2
Notes:
Trunks
Indirect LCR: System will send a pre-assigned code (set in the ARS Dial Conversion Tables) when an
extension seizes the trunk to make an outgoing call. This feature is used in the U.K. for sending a
system identification PIN number to the CO.
FF3
U.S.A.: Do not enable this address for MCO access code routing (eg., dialing "9" to get an outside line).
Extensions
Instead, use ARS tables (see FF6) so the system can distinguish intercom calls from outgoing calls.
Related Programming:
FF4
FF6 2 05: Digit Modify Table (pg. 6-38)
FF-/Soft Keys
FF5
Groups
Not Used
(all CPCs) - Version 1.0 or higher
FF6
FF2 0 BSSC
TRS/ARS
FF2 0 BSSC
FF7
Applications
FF2 0 BSSC
FF8
Maintenance
Appendix A
Appendix B
576-13-400
FF2 0 BSSC
02 18 Hold
02 19 Hold
02 20 Hold
DBS 576 (USA) issued 05/20/98
FF2: Trunk Programming (Analog CO)
02 17 Hold (0 or 1) Hold
0=Disable Indirect LCR. (default)
1=Enable Indirect LCR.
Introduction
$ %
 ' 5
0
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
$ 
)! B TRS/ARS
$ &
)! B
FF7
Applications
$
)! B
FF8
Maintenance
Appendix A
Appendix B
Page 2-27
System