HP StorageWorks 2/16 - SAN Switch Manual page 187

source port
destination
port
basic stats
extended
stats
trace
reverse
path
source
route:
strict
source rte
Timeout
Examples
To invoke pathinfo with all operands on the command line:
switch:admin> pathInfo 91
Fabric OS 3.x Document Addendum
The port whose path to the destination domain is sought. It can be
an F_Port or an E_Port. The embedded port (-1) is used by
default. For a switch with blades, this is specified as the area;
otherwise, it is the port.
A port on the destination switch. The pathinfo command
returns the state of the port, and all requested statistics pertaining
to the port. The embedded port (-1) is used by default, or if the
specified destination port is not an existing active port. For a
switch with blades, this is specified as the area, otherwise the port.
Requests the reporting of basic statistics on every link; default is
no.
Requests the reporting of extended statistics on every link; default
is no.
Provides path information from the destination port to the source
port; default is no.
Specifies a sequence of switches or ports that the pathinfo frame
should hop. Note that if an output port (or area) to the next hop is
specified, the user is not prompted for the domain of the next
switch that is determined by the port (or area) specified. Default:
no.
Specifies that the source route must be followed strictly as
indicated, skipping possible intermediate switches. When using
this option, the source route must be specified using domain
numbers (rather than the output port).
The maximum time allowed to wait for the response; default is 10
seconds.
Target port is Embedded
Hop In Port Domain ID (Name)
---------------------------------------------------------
0 E 9 (web226)
1 3 10 (web229)
2 8 8 (web228)
3 6 91 (web225)
Fabric OS reference guide
Out Port BW Cost
2 1G 1000
8 1G 1000
9 1G 1000
E - -
187