Agtcfgshow - HP StorageWorks 2/16 - SAN Switch Manual

agtcfgshow

Displays the SNMP agent configuration.
Syntax
agtcfgshow
Availability
All users
Description
This command displays the configuration of the SNMP agent in the switch. The following
fields are displayed:
sysDescr
sysLocation
sysContact
swEventTrapLevel
authTrapsEnabled
In addition, there are six communities and respective trap recipients supported by the agent.
The first three communities are for read-write access (rw) and the last three are for read-only
access (ro).
For an SNMP management station to receive a trap generated by the agent, the administrator
must configure a trap recipient value to correspond to the IP address of the management
station.
Fabric OS 3.x Document Addendum
The system (switch) description (in MIB-II definition). The
default value is Fibre Channel Switch.
The location of the system (switch) (in MIB-II definition). The
default value is End User Premise.
The contact information for this system (switch). The default
value is Field Support.
The event trap level with the event's severity level. When an
event occurs, if its severity level is at or below the set value,
the SNMP trap and swEventTrap is sent to configured trap
recipients. By default, this value is set at 0, which means that
no swEventTrap is sent. Possible values are:
— 0 none
— 1 critical
— 2 error
— 3 warning
— 4 informational
— 5 debug
See for related information.
errshow
The authentication trap, authenticationFailure, is transmitted
to the configured trap recipient when the agent receives a
protocol message that is not properly authenticated. In the
context of SNMPv1 and SNMPv2c, the agent receives a
protocol message with an unmatched community string value.
The factory default value is false.
Fabric OS reference guide
157