HP StorageWorks 2/16 - SAN Switch Manual page 117

SEC-PIDCHGERR, PID Change failed: Size check failed
Message
<timestamp>
ERROR SEC-PIDCHGERR, 2, PID Change failed: Size check failed. <defined
status> <active status>
Probable Cause
Either the new defined or new active policy was too large after modifying the area ID. The
status values can be defined, active, or both. A negative value means that a policy set
was failed by the daemon.
Recommended Action
Reduce the size of the specified policy database.
Severity
ERROR
SEC-PIDCHGERR, Change failed: Can't get sec_db
Message
<timestamp>
ERROR SEC-PIDCHGERR, 2, Change failed: Switch is busy. Operation failed.
Probable Cause
The switch security daemon is busy. The status values can be defined, active, or both. A
negative value means that a policy set was failed by the daemon.
Recommended Action
For the first reject, wait a few minutes and then resubmit the transaction. Fabric-wide
commands might take a few minutes to propagate throughout the fabric. Make sure to leave
enough time so your commands do not overlap in the fabric.
Severity
ERROR
Fabric OS 3.x Document Addendum
Diagnostic and system error messages reference guide
117