Zoning Operation Parameter; Rscn Transmission Mode; Arbitrated Loop Settings - HP StorageWorks 2/16 - SAN Switch Manual

Table 15: Zoning Operation Parameter
Disable Nodename Zone Checking
Disable Nodename Zone Checking
By default, zoning uses both port WWN and node WWN to perform zoning. When the option
is set to 1, node WWN cannot be used in zoning.

RSCN Transmission Mode

Table 16
table.
Table 16: RSCN Transmission Mode
End-Device RSCN Transmission Mode
Domain RSCN-to-End Device for Switch IP
Address or Name Change
End-Device RSCN Transmission Mode
End-device RSCN transmission mode values are:
Domain RSCN-to-End Device for Switch IP Address or Name Change
Domain RSCN to end-device for switch IP address or name change values are:

Arbitrated Loop Settings

Table 17
field is described after the table.
Table 17: Arbitrated Loop Settings
Send FAN frames?
Always send RSCN?
Enable CLOSE on OPEN Received?
Do Not Allow AL_PA 0x00?
Initialize All Looplets?
Fabric OS 3.x Document Addendum
Field
provides the RSCN transmission mode values. Each field is described following the
Field
0 RSCN contains only a single PID.
1 RSCN contains multiple PIDs.
2 Fabric address RSCN.
0 Disabled. No domain RSCN is sent to the end device for a switch IP address change or
a name change.
1 Enabled. Domain RSCN is sent to the end device for a switch IP address change or a
name change.
defines settings affecting Fibre Channel arbitrated loops that can be changed. Each
Field
Type Default
Boolean 0 0 or 1
Type Default
Number 1
Number 0
Type Default
Boolean 1
Boolean 0
Number 4
Boolean 0
Boolean 0
Fabric OS reference guide
Range
Range
0 to 2
0 to 1
Range
0 or 1
0 or 1
0 to 4
0 or 1
0 or 1
169