Accessing Nokia Network Voyager - Nokia IP350 - Security Appliance Installation Manual

3
Performing the Initial Configuration
c. Reboot the appliance.
d. Respond to the
3. At each subsequent prompt, type the requested configuration information
and then press Enter.
For more information about how to respond to the prompts during the
initial configuration process, see the release notes for the Nokia software
release you are running.
4. After you complete the initial configuration, you can use Voyager to
configure the remaining network ports.

Accessing Nokia Network Voyager

You can use Voyager to configure the remaining network ports on your 60s
and 100s appliances.
To open Voyager
1. Start Netscape Navigator or Microsoft Internet Explorer on the host you
want to use to complete the configuration.
2. In the Location or Address field, enter the IP address of the initial
interface you configured on the appliance.
You are prompted to enter the admin username and the password you
entered when performing the initial configuration.
Note
If the username popup menu does not appear, you might not have a
network connection between the host and your 60s and 100s
34
rm /config/active
or
mv /config/active
Hostname?
DHCP client from restarting.
/config/active.old
prompt within 30 seconds to prevent the
Nokia 60s and 100s Installation Guide