Installing A Pcmcia Modem - Nokia IP350 - Security Appliance Installation Manual

6
Installing and Replacing Other Components

Installing a PCMCIA Modem

The 60s and 100s appliances support a PCMCIA modem card that allows you
to set the country code through Voyager. For information about the country
codes, see the Voyager Reference Guide.
Note
The 60s and 100s support Ositech Five of Clubs and Ositech Five of
Clubs II PCMCIA modems. Nokia recommends that you purchase your
modem only from Nokia or authorized resellers. For further information,
contact the appropriate Nokia customer support site listed
Information"
To use a modem with a 60s or 100s appliance
1. If the modem is not already installed, insert the PCMCIA modem into
either the top or bottom PCMCIA slot until the modem clicks into place.
The modem and the ejector tab on the left of the slot protrude from the
unit. The appliance automatically recognizes the modem.
2. Connect the modem to a phone line.
Use the appropriate cable for the modem and telephone system in the
country in which the device is used.
To configure IPSO to allow logins through the modem, click Config on the
Home page in Voyager and then click on the Network Access and Services
link in the Security and Access Configuration section.
52
on page 3.
PCMCIA Slots
Nokia 60s and 100s Installation Guide
"Nokia Contact
60s
00487