Adding Or Replacing Dimms - Nokia IP350 - Security Appliance Installation Manual

Caution
To protect the 60s or 100s appliance and the memory modules from
electrostatic discharge (ESD), make sure you are properly grounded
before you touch these components.
Note
Because power to a 60s or 100s appliance is automatically disconnected
when the chassis assembly is opened, you do not need to manually
disconnect the power for this procedure. Any servicing of the unit,
however, should be completed with the chassis assembly fully removed
from the appliance. Power is still active in the chassis body and care
should be taken when working on the power supply or power supply
wiring without disconnecting the power cord.

Adding or Replacing DIMMs

To add or replace DIMMs
1. Use Voyager or Lynx to perform an orderly shutdown of the 60s or 100s
Nokia 60s and 100s Installation Guide
appliance.
For information about accessing Voyager, see
Voyager" on page 34.
Replacing or Upgrading Memory
"Accessing Nokia Network
59