Nokia IP350 - Security Appliance Installation Manual page 54

6
Installing and Replacing Other Components
To replace a hard-disk drive
1. Use Voyager to shut the system down.
For information about how to access Voyager, see
Network Voyager"
2. Loosen the thumbscrews that hold the chassis assembly.
3. Gently slide the chassis assembly forward to remove the tray from the
appliance so you can access the hard-disk drive retaining screws from the
bottom of the tray.
Note
Because power to a 60s or 100s is automatically disconnected when
the chassis assembly is opened, you do not need to manually
disconnect the power for this procedure. Any servicing of the unit,
however, should be completed with the chassis assembly fully
removed from the appliance. Power is still active in the chassis body
54
on page 34.
Chassis assembly thumbscrews
Nokia 60s and 100s Installation Guide
"Accessing Nokia
60s
00487
00489