Nokia IP350 - Security Appliance Installation Manual page 82

7
Using the Boot Manager
Nokia customer support site listed in the Nokia Contact Information section at
the front of this guide for instructions and a new boot manager.
The command to install the boot manager has the following syntax:
install_bootmgr boot-device boot-file
where boot-device is the storage device to which you write the new boot
manager image and from which boot manager image loads at boot up.
Boot-file is the new boot manager. The new boot manager options are
cpipflash
command from IPSO (the operating system), not from the boot manager.
Note
To install the new boot manager, you must be in single-user mode.
To install the new boot manager
1. Start the appliance in single-user mode.
2. At the IPSO command prompt, enter:
/etc/install_bootmgr wd0 /image/current/bootmgr/
nkipflash
The command installs the new boot manager image (
flash device (
interrupt the installation process.
82
, , and
nkipflash nkvpnflash
). The installation takes some time to complete. Do not
wd0
. Execute the
install_bootmgr
nkipflash
Nokia 60s and 100s Installation Guide
) into the