To remove, install, or replace a network interface card
1. Use Network Voyager to shut the system down.
2. Use your fingers or a screwdriver to loosen the thumbscrews that hold the
Nokia 60s and 100s Installation Guide
Note
Because power to 60s and 100s appliances is automatically
disconnected when the chassis assembly is opened, you do not need
to manually disconnect the power for this procedure. Any servicing of
the unit, however, should be completed with the chassis assembly
fully removed from the appliance. Power is still active in the chassis
body and care should be taken when working on the power supply or
power supply wiring without disconnecting the power cord.
For information about how to access Voyager, see
Network Voyager"
on page
chassis assembly.
Removing, Installing, and Replacing NICs
34.
Chassis assembly thumbscrews
"Accessing Nokia
60s
00487
39